Which two statements about the seamless EVPN-VXLAN stitching interconnect gateways are correct? (Choose two.)

1. A. IBGP is recommended for VXLAN stitching overlays.
2. B. Interconnect gateways will rewrite the route target, route distinguishe
3. C. and ESI values for each stretched virtual network.
4. D. All EVPN routes types are forwarded among interconnect gateways in a full-mesh manner.
5. E. The interconnect gateway can reside on the super spine layer of a multi-POD data center.

Correct Answer: CD

Exhibit.

The two data centers shown in the exhibit need to be connected using EVPN. Which two statements are correct in this situation? (Choose two.)

1. A. Hosts in VLAN 10 can communicate with hosts in Data Center 2 using Layer 3.
2. B. Hosts in VLAN 10 can communicate with hosts in Data Center 2 using Layer 2.
3. C. Hosts in VLAN 202 can communicate using Layer 3 between data centers.
4. D. Hosts in VLAN 202 can communicate using Layer 2 between data centers.

Correct Answer: AD

You are asked to configure JTI on the QFX Series devices in your data center fabric. You must use sensors with the least amount of latency. Which type of sensor should you use in this scenario?

1. A. Python sensors
2. B. JTI native sensors
3. C. analog sensors
4. D. JTI OpenConfig sensors

Correct Answer: B

You are asked to enable visibility into your EVPN-VXLAN network traffic by monitoring traffic continuously. Which two statements are correct in this scenario? (Choose two.)

1. A. You cannot enable sFlow monitoring on each interface individually.
2. B. The sFlow agent is installed by default on your OFX Series switch.
3. C. You must enable sFlow monitoring on each interface individually.
4. D. The sFlow agent needs to be manually installed on your QFX Series switch.

Correct Answer: BC

You are asked to deploy an Ethernet bridging design in a data center with the following criteria:
--routing must occur on the leaf devices.
--VTEPs must terminate on the leaf devices.
--facilitate inter-VLAN communication, -- lower latency with East-West traffic. Which architecture should you use in this scenario?

1. A. collapsed spine architecture
2. B. edge-routed bridging architecture
3. C. bridge overlay architecture
4. D. centrally-routed bridging architecture

Correct Answer: B