DRAG DROP
Match each description to the correct management tool for Aruba AOS-CX.
Select and Place:

Solution:


Does this meet the goal?

1. A. Yes
2. B. No

Correct Answer: A

Refer to the exhibit

What is true regarding VLAN 50 according to the diagram above?

1. A. VLAN 50 is part of a switched virtual interface (SVI) that was never routed causing it to be down.
2. B. Since VLAN 50 has not been assigned to any enabled physical port, the status is down.
3. C. VLAN 50 is assigned only to Trunk ports which is why no ports are listed under interfaces.
4. D. VLAN 50 was never added to the vlan-database and therefore is in a down state.

Correct Answer: B

Refer to the exhibit.

You are in the process of configuring VSF between Access-1 and Access-2. Access-1 has been configured as the VSF Master. What is a valid configuration for Access-2 to join the VSF stack?

1. A. Access-2# configureAccess-2(config)# vsf member 1 Access-2(config)# vsf renumber-to 2 Access-2(vsf-member-1)# link 2 2/1/28 Access-2(vsf-member-1)# exitThis will save the VSF configuration and reboot the switc
2. B. Do you want to continue (y/n)? y
3. C. Access-2# configureAccess-2(config)# vsf member 2 Access-2(vsf-member-1)# link 2 1/1/28 Access-2(vsf-member-1)# exitThis will save the VSF configuration and reboot the switc
4. D. Do you want to continue (y/n)? y
5. E. Access-2# configureAccess-2(config)# vsf member 2 Access-2(vsf-member-1)# link 1 1/1/28 Access-2(vsf-member-1)# exitThis will save the VSF configuration and reboot the switch.Do you want to continue (y/n)? y
6. F. Access-2# configureAccess-2(config)# vsf member 1 Access-2(vsf-member-1)# link 1 1/1/28 Access-2(vsf-member-1)# exitAccess-2(config)# vsf renumber-to 2This will save the VSF configuration and reboot the switc
7. G. Do you want to continue (y/n)? y

Correct Answer: C

What are two mechanisms supported on AOS-CX 6300 switches used in Multi-active Detection to determine the status of the Primary member? (Choose two.)

1. A. Management interface split detection
2. B. Peer switch-based detection
3. C. Loopback keepalives
4. D. ARP-based
5. E. BFD

Correct Answer: AD

Refer to the exhibit.

All switches are running Aruba OS-CX. While working in the terminal of Access-2, you are unable to reach Server-1 using SSH. What is the correct command to ping Server-1 from Access-2 to test reachability?

1. A. Access-2# ping6 172.16.1.97 vrf mgmt
2. B. Access-2# ping 172.16.1.97
3. C. Access-2# ping 172.16.1.97 vrf default
4. D. Access-2# ping 172.16.1.97 vrf mgmt

Correct Answer: D