Which three statements describes Service Profiles?

1. A. Service Profiles define a standard convention for WWNs agreed upon by all stakeholders for address blocks
2. B. Service Profiles use Cisco’s OUI (00:25:B5) for the 3rd to 5th octets in WWN
3. C. Service Profiles are only applicable to network configurations
4. D. Service Profiles use the same hex value for 1st and 2nd octets in WWNN and WWPN
5. E. Service Profiles are a logical view of a server without any tie to physical components
6. F. Service Profiles are grouped by virtual machine operating system

Correct Answer: C

How do service profiles enable workload mobility?

1. A. Service Profiles represent a physical view of a server without any ties to specific virtual hardware
2. B. Service Profiles work with the underlying hypervisor and communicate with the VM to detect workload movement
3. C. Service Profiles represent a logical view of a server without any ties to specific physical hardware
4. D. Service Profiles communicate workload movement to VCenter

Correct Answer: A

ACME technologies is deploying a large number of similar UCS blade servers and want to be able to change servers policies at a later time on all blades. What type of the Cisco UCS design is recommended?

1. A. Initial template based service profiles
2. B. Updating template based service profile
3. C. Updating non-template based service profiles
4. D. Initial non-template based service profiles

Correct Answer: B

Your System BIOS has ‘Hyper Threading’ enabled. However, you just created a BIOS Policy that has ‘Hyper Threading’ disabled. You attached this BIOS Policy to a Service Profile and associated this Service Profile to the existing Server. What action will occur next?

1. A. The System BIOS takes precedence over the ‘BIOS Policy’, so ‘Hyper Threading’ will remain enabled
2. B. The ‘BIOS Policy’ takes precedence over the System BIOS, so ‘Hyper Threading’ will be disabled
3. C. The UCS Server will fail due to a mismatch configuration
4. D. Some BIOS settings cannot be changed in UCS Servers, ‘Hyper Threading’ is one of them

Correct Answer: B

What condition requires Inter VSAN Routing (IVR)?

1. A. The targets are in the same Initiator Group.
2. B. When the path between source and destination edge VSANs require the traffic to pass through several VSANs before reaching the destination.
3. C. When using MDS 9000 series SAN Directors.
4. D. Transit VSANs are integral to the IVR architecture and are always required.

Correct Answer: B