A user forwards a corporate number to an international number. What are two methods to prevent this forwarded call? (Choose two.)

1. A. Configure a Forced Authorization Code on the international route pattern.
2. B. Block international dial patterns in the SIP trunk CSS.
3. C. Set Call Forward All CSS to restrict international dial patterns.
4. D. Set the Call Classification to OnNet for the international route pattern.
5. E. Check Route Next Hop By Calling Party Number on the international route pattern.

Correct Answer: AC

An administrator installed a Cisco Unified IP 8831 Conference Phone that is failing to register. Which two actions should be taken to troubleshoot the problem? (Choose two.)

1. A. Verify that the switch port of the phone is enabled.
2. B. Verify that the RJ-11 cable is plugged into the PC port.
3. C. Disable HSRP on the access layer switch.
4. D. Check the RJ-65 cable.
5. E. Verify that the phone's network can access the option 150 server.

Correct Answer: AE

A collaboration engineer configures Global Dial Plan Replication for multiple Cisco UCM clusters. The local cluster acts as the hub cluster, and the remaining clusters act as spoke clusters Which service must the engineer configure on the local cluster’

1. A. Intercluster Lookup Service
2. B. Location Conveyance on intercluster SIP trunks
3. C. Intra-Cluster Communication Signaling
4. D. Mobility Cross Cluster

Correct Answer: A

An administrator would like to set several Cisco Jabber configuration parameters to only apply to mobile clients (iOS and Android). How does the administrator accomplish this with Cisco Jabber 12.9 and Cisco UCM 12.5?

1. A. Assign the desired configuration file to "Mobile" Jabber Client Configuration in the Service Profile.
2. B. Upload the jabber-config.enc file to TFTP
3. C. Create a user profile in Jabber Policies.
4. D. Deploy jabber-config-user.xml on iOS and Android devices.

Correct Answer: A

An engineer troubleshoots outbound can failure on an ISDN-PRI circuit. The engineer ts suspecting the 'Incomplete Destination". Which debugs or commands are run in the voice gateway to troubleshoot the issue?

1. A. debug isdn q921term mon
2. B. debug voip ecapi inout show controller ti
3. C. debug isdn q931 show isdn status
4. D. debug isdn q921 debug voip ecapi inout

Correct Answer: C
The engineer should run the following debugs or commands in the voice gateway to troubleshoot the issue: debug isdn q931 - This debug will show the ISDN Q.931 messages that are being exchanged between
the voice gateway and the ISDN switch. This can be used to identify the cause of the "Incomplete Destination" error.
show isdn status - This command will show the status of the ISDN PRI circuit. This can be used to verify that the circuit is up and running.
The other options are not correct. The debug isdn q921 command will show the ISDN Q.921 messages that are being exchanged between the voice gateway and the ISDN switch. This is not necessary for troubleshooting the issue. The term mon command will show the terminal monitor output. This is not necessary for troubleshooting the issue. The debug voip ecapi inout command will show the VoIP ECAP messages that are being exchanged between the voice gateway and the VoIP server. This is not necessary for troubleshooting the issue. The show controller ti command will show the status of the T1 controller. This is not necessary for troubleshooting the issue.