An engineer must configure HTTPS secure management for Cisco UCS Manager using a key ring named kr2016 and a key size of 1024 bits. The environment consists of a primary fabric interconnect named UCS-A and a secondary fabric interconnect named UCS-B. Which command sequence must be used to accomplish this goal?

1. A. Option A
2. B. Option B
3. C. Option C
4. D. Option D

Correct Answer: B
https://www.cisco.com/en/US/docs/unified_computing/ucs/sw/cli/config/guide/1.4.1/CLI_Config_Guide_1_4_1

An engineer is implementing FCoE. Which aspect of DCBXP on a Cisco Nexus switch affects this
implementation?

1. A. It uses the Cisco Fabric Services protocol to exchange parameters between two peer links.
2. B. It always is enabled on 10/100-Mbps native Ethernet ports.
3. C. It provides the authentication of peers on the Cisco Nexus switch.
4. D. It requires that LLDP transmit and LLDP receive are enabled on the FCoE interface.

Correct Answer: D
The Data Center Bridging Exchange Protocol (DCBXP) is an extension of LLDP. It is used to announce, exchange, and negotiate node parameters between peers. DCBXP parameters are packaged into a specific DCBXP TLV. This TLV is designed to provide an acknowledgement to the received LLDP packet. DCBXP is enabled by default, provided LLDP is enabled. DCBXP is disabled on ports where LLDP transmit or receive is disabled. https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/layer2/503_n2_1/b_Cisco_n5k_layer2

An engineer is configuring VNTag between a virtualized server and a Cisco Nexus 5500 Series switch. Drag and drop the configuration steps from the into the correct order on the right.

Solution:
install the virtualization feature set Enable the virtualization feature set Configure the port profile
Configure support for VNTag mode on the interface that connects to the server. Configure the server to support NIV mode
Configure the vNICs of the server
https://www.cisco.com/c/en/us/support/docs/switches/nexus-5000-series-switches/117691-config- 5500switch-00.html https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5500/sw/adapter-fex/6x/ b_5500_Adapter_FEX_Config_6x/ b_5500_Adapter_FEX_Config_602N11_chapter_010.html

Does this meet the goal?

1. A. Yes
2. B. No

Correct Answer: A

What is a feature of NFS?

1. A. role-based access control
2. B. Kerberos-based security model
3. C. block-based file access
4. D. zone-based access control

Correct Answer: B
https://www.cisco.com/c/en/us/support/docs/security-vpn/kerberos/16087-1.html#modifiednfs

Refer to the exhibit.

An engineer must deploy 70 Cisco Nexus 9000 Series Switches in a new environment The requirement is to use Cisco DCNM as a management tool to deploy, manage and monitor the new switches. In addition. DCNM is configured with a zero-touch POAP feature to facilitate fabric creation Which action meets these requirements?

1. A. Configure SNMP on the new Nexus switches to send SNMP messages to the DCNM server
2. B. Create a SPAN session on the management switch to send the traffic from VLAN 10 to Ethernet 1/1.
3. C. Configure an IP helper address on interface VLAN 10 of the management switch
4. D. Create common credentials on all of the new Nexus switches

Correct Answer: C