- (Exam Topic 2)
An engineer must configure the strongest password authentication to locally authenticate on a router. Which configuration must be used?

1. A. Option A
2. B. Option B
3. C. Option C
4. D. Option D

Correct Answer: D
Scrypt is safer than MD5, so answer A is wrong and answer D is correct
R1(config)#username user secret ?0 Specifies an UNENCRYPTED secret will follow5 Specifies a MD5 HASHED secret will follow8 Specifies a PBKDF2 HASHED secret will follow9 Specifies a SCRYPT HASHED secret will follow<0-9> Encryption types not explicitly specifiedLINE The UNENCRYPTED (cleartext) user secretLINE The UNENCRYPTED (cleartext) user secret
Reference: https://community.cisco.com/t5/networking-documents/understanding-the-differences-between-the

- (Exam Topic 4)
By default, which virtual MAC address does HSRP group 30 use?

1. A. 00:05:0c:07:ac:30
2. B. 00:00:0c:07:ac:1e
3. C. 05:0c:5e:ac:07:30
4. D. 00:42:18:14:05:1e

Correct Answer: B

- (Exam Topic 2)
Refer to the exhibit.

An engineer is troubleshooting an application running on Apple phones. The application Is receiving incorrect QoS markings. The systems administrator confirmed that ail configuration profiles are correct on the Apple devices. Which change on the WLC optimizes QoS for these devices?

1. A. Enable Fastlane
2. B. Set WMM to required
3. C. Change the QoS level to Platinum
4. D. Configure AVC Profiles

Correct Answer: C

- (Exam Topic 2)
What is the wireless received signal strength indicator?

1. A. The value given to the strength of the wireless signal received compared to the noise level
2. B. The value of how strong the wireless signal Is leaving the antenna using transmit power, cable loss, and antenna gain
3. C. The value of how much wireless signal is lost over a defined amount of distance
4. D. The value of how strong a tireless signal is receded, measured in dBm

Correct Answer: D
RSSI, or “Received Signal Strength Indicator,” is a measurement of how well your device can hear a signal from an access point or router. It’s a value that is useful for determining if you have enough signal to get a good wireless connection.
This value is measured in decibels (dBm) from 0 (zero) to -120 (minus 120). The closer to 0 (zero) the stronger the signal is which means it’s better, typically voice networks require a -65db or better signal level while a data network needs -80db or better.

- (Exam Topic 1)
A customer has several small branches and wants to deploy a WI-FI solution with local management using CAPWAP. Which deployment model meets this requirement?

1. A. Autonomous
2. B. Mobility Express
3. C. SD-Access wireless
4. D. Local mode

Correct Answer: B