Refer to the exhibit.

A network engineers configuring the switch to accept downloadable ACLs from a Cisco ISC server Which two commands should be run to complete the configuration? (Choose two)

1. A. aaa authorization auth-proxy default group radius
2. B. radius server vsa sand authentication
3. C. radius-server attribute 8 include-in-access-req
4. D. ip device tracking
5. E. dot1x system-auth-control

Correct Answer: BC

What are two components of the posture requirement when configuring Cisco ISE posture? (Choose two)

1. A. updates
2. B. remediation actions
3. C. Client Provisioning portal
4. D. conditions
5. E. access policy

Correct Answer: BD

An engineer is configuring the remote access VPN to use Cisco ISE for AAA and needs to conduct posture checks on the connecting endpoints After the endpoint connects, it receives its initial authorization result and continues onto the compliance scan What must be done for this AAA configuration to allow compliant access to the network?

1. A. Configure the posture authorization so it defaults to unknown status
2. B. Fix the CoA port number
3. C. Ensure that authorization only mode is not enabled
4. D. Enable dynamic authorization within the AAA server group

Correct Answer: D

Refer to the exhibit.

An engineer is configuring a client but cannot authenticate to Cisco ISE During troubleshooting, the show authentication sessions command was issued to display the authentication status of each port Which command gives additional information to help identify the problem with the authentication?

1. A. show authentication sessions
2. B. show authentication sessions Interface Gil/0/1 output
3. C. show authentication sessions interface Gi1/0/1 details
4. D. show authentication sessions output

Correct Answer: C

An engineer is using Cisco ISE and configuring guest services to allow wireless devices to access the network. Which action should accomplish this task?

1. A. Create the redirect ACL on the WLC and add it to the WLC policy
2. B. Create the redirect ACL on the WLC and add it to the Cisco ISE policy.
3. C. Create the redirect ACL on Cisco ISE and add it to the WLC policy
4. D. Create the redirect ACL on Cisco ISE and add it to the Cisco ISE Policy

Correct Answer: B