An engineer removes a VMM domain from an endpoint group called EPG-1, but the distributed port group fails to be deleted. Which action must be taken to resolve the issue?

1. A. Remove the port group manually.
2. B. Migrate all virtual machines in the EPG-1 to different hypervisors.
3. C. Remove the remaining EPGs from the VMM domain.
4. D. Migrate all virtual machines in the EPG-1 to different port groups.

Correct Answer: C

You have an ACI environment with three APICs, two spine switches, and four-leaf switches. You wipe and reboot all APICs first then leaf and spine switches one-by-one and successfully go through the Initial Setuo dialogue on the APIC 1 CIMC KVM console. When you log in to the APIC1 WebGUI, you notice that you do not see any directly connected leaf switches being discovered under Fabric > Inventory > Fabric Membership. What is the cause of the issue?

1. A. The leaf nodes were not erased properly, which caused a fabric parameters mismatch with the APIC1.
2. B. Rebooting the APICs and the leaf and spine switches after wiping them is not required.
3. C. You forgot to enter the TEP Pool value during the Initial Setup dialogue on APIC1.
4. D. The same Fabric Name value should be used before after wiping all devices.

Correct Answer: C

A customer configures HSRP between two data centers that are interconnected with OTV. The configuration succeeds, but traffic between two ESXi virtual hosts on the same site is routed suboptimally through the OTV overlay. Which two actions optimize the traffic? (Choose two.)

1. A. Disable first-hop redundancy.
2. B. Filter HSRP traffic by using a Layer 3 VACL on the OTV edge devices.
3. C. Filter HSRP by using a Layer 2 MAC-list on the ESXi vSwitch.
4. D. Filter HSRP traffic by using a Layer 3 VACL on the ESXi vSwitch.
5. E. Filter HSRP by using a Layer 2 MAC-list on the OTV edge devices.

Correct Answer: AB

An engineer must replace a failed memory on a Cisco UCS B-Series Blade Server. After the replacement was done, the server has a “resolve slot” warning. Which server maintenance action resolves the issue?

1. A. Perform diagnostic interrupt on the server.
2. B. Re-acknowlegement the server.
3. C. Reset the server.
4. D. Decomission the server.

Correct Answer: B

An engineer is troubleshooting a packet flow from an access leaf to spine. Which EVPN routes are expected on this connection?

1. A. EVPN Type 1-5
2. B. EVPN Type 0,9,15
3. C. EVPN Type 9-15
4. D. EVPN Type 0,16

Correct Answer: A