An engineer is reducing the subnet size of the corporate WLAN by segmenting the VLAN into smaller subnets. Clients will be assigned a subnet by location. Which type of groups can the engineer use to map the smaller subnets to the corporate WLAN?

1. A. WLC port groups
2. B. RF groups
3. C. AP groups
4. D. interface groups

Correct Answer: D

How are mobility groups created, excluding mobility anchors?

1. A. The WLGs do not have to be of the same model or type to be a member of a mobility group, however each member should be running different software versions.
2. B. A mobility group does not require ell WLCs in the group lo use the same virtual IP address.
3. C. Each WLC must use the same mobility domain name and be defined as a peer in each other' s static mobility members list.
4. D. If WLCs with HA SSO are deployed, each WLC in the WLC HA pair is considered separately as a mobility peer.

Correct Answer: D

An engineer has successfully configured high availability and SSO using two Cisco 5508 Wireless LAN Controllers. The engineer can access the Active Primary WLC, but the Secondary Standby WLC is not accessible. Which two methods allow access to the standby unit? (Choose two.)

1. A. via the console connection
2. B. SSH to the redundancy management interface of the primary WLC
3. C. SSH to the service port interface
4. D. SSH to the virtual interface of the secondary WLC
5. E. SSH to the management interface of the primary WLC

Correct Answer: AC

During a post-deployment site Survey, issues are found with non wi-Fi interference. What should the
engineer use to identify the source of the Interference?

1. A. Network analysis module
2. B. Wireless intrusion prevention
3. C. Wireshark
4. D. Cisco spectrum expert

Correct Answer: D

A wireless engineer must optimize RF performance for multiple buildings with multiple types of construction and user density. Which two actions must be taken? (Choose two.)

1. A. Configure Flexconnect groups for each building.
2. B. Configure WMM profiles for each building.
3. C. Configure AP groups for each area type.
4. D. Configure RF profiles for each area type.
5. E. Enable DTPC on the network.

Correct Answer: CD
https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-10/config-guide/b_cg810/configuring_ap_groups.ht