A network engineer must configure all branches to communicate with each other through the Service Chain Firewall located at the headquarters site. Which configuration allows the engineer to accomplish this task?
A)

B)

C)

D)

1. A. Option A
2. B. Option B
3. C. Option C
4. D. Option D

Correct Answer: B

Which protocol is used to measure jitter, loss, and latency on SD-WAN overlay tunnels?

1. A. QoE
2. B. OMP
3. C. BGP
4. D. BFD

Correct Answer: D

Which device should be configured with the service chain IP address to route intersite traffic through a firewall?

1. A. vSmart
2. B. firewall
3. C. spoke WAN Edge
4. D. hub WAREdge

Correct Answer: A

Which actions must be taken to allow certain departments to require firewall protection when interacting with data center network without including other departments? (Choose two.)

1. A. Use classification policing and marking
2. B. Apply data policies at vEdge.
3. C. Deploy a service-chained firewall service per VPN
4. D. The regional hub advertises the availability of the firewall service
5. E. Advertise lo vSmart controllers

Correct Answer: CD

What is the result during a WAN Edge software upgrade process if the version of the WAN Edge software is higher than the one running on a controller device?

1. A. The upgrade button is greyed out
2. B. The upgrade proceeds with no warning message.
3. C. The upgrade fails with a warning message
4. D. The upgrade proceeds with a warning message

Correct Answer: D