A BIG-IP Administrator is checking the BIG-IP device for known vulnerabilities. What should the 8IG-IP Administrator upload to BIG-IP iHealth for further analysis?

1. A. QKView
2. B. EUD
3. C. UCS
4. D. tcpdump

Correct Answer: A

A BIG-IP Administrator uses a device group to share the workload and needs to perform service on a BIG-IP device currently active for a traffic group. The administrator needs to enable the traffic group to run on another BIG-IP device in the device group. What should the administrator do to meet the requirement?

1. A. Create a new Traffic Group and then fail to Standby Unit
2. B. Select Traffic Group and then select Failover
3. C. Select Traffic Group and then select Force to Standby
4. D. Select Traffic Group on Primary Unit and then select Demote

Correct Answer: C

A BIG-IP Administrator needs to have a BIG-IP linked to two upstream switches for resilience of the external network. The network engineer who is going to configure the switch instructs the BIG-IP Administrator to configure interface binding with LACP. Which configuration should the administrator use?

1. A. A virtual server with an LACP profile and the switches' management IPs as pool members.
2. B. A virtual server with an LACP profile and the interfaces connected to the switches as pool members.
3. C. A Trunk listing the allowed VLAN IDs and MAC addresses configured on the switches.
4. D. A Trunk containing an interface connected to each switch.

Correct Answer: D

A site wishes to perform source address translation on packets from some clients but not others. The determination is not based on the client's IP address, but on the virtual servers their packets arrive on. What could best accomplish this goal?

1. A. A SNAT for all addresses could be defined, and then disable the SNAT processing for select VLANs.
2. B. Some virtual servers could be associated with SNAT pools and others not associated with SNAT pools.
3. C. The decision to perform source address translation is always based on VLA
4. D. Thus, the goal cannot be achieved.
5. E. The decision to perform source address translation is always based on a client's address (or network).Thus, this goal cannot be achieved.

Correct Answer: B

Refer to the exhibit


The network team creates a new VLAN on the switches. The BIG-IP Administrator needs to create a configuration on the BIG-IP device. The BIG-IP Administrator creates a new VLAN and Self IP, but the servers on the new VLAN are NOT reachable from the BIG-IP device.
Which action should the BIG-IP Administrators to resolve this issue?

1. A. Set Port Lockdown of Set IP to Allow All
2. B. Change Auto Last Hop to enabled
3. C. Assign a physical interface to the new VLAN
4. D. Create a Floating Set IP Address

Correct Answer: C