Refer to the exhibit. The BIG-IP Administrator needs to avoid overloading any of the Pool Members with connections, when they become active.
What should the BIG-IP Administrator configure to meet this requirement?

1. A. Different Ratio for each member
2. B. Same Priority Group to each member
3. C. Action On Service Down to Reselect
4. D. Slow Ramp Time to the Pool

Correct Answer: D

A BIG-IP Administrator needs to restore an encrypted UCS archive from the command line using the TMSH utility.
Which TMSH command should the BIG-IP Administrator use to accomplish this?

1. A. load/sys ucs <filepath> passphrase <password>
2. B. load/sys config file <filepath> passphrase <password>
3. C. load/sys config file <filepath>
4. D. load/sys ucs <filepath> no-license

Correct Answer: A

An application is configured so that the same pool member must be used for an entire session, as well as for HTTP and FTP traffic.
A user reports that a session has terminated, and the user must restart the session. The BIG-IP Administrator determines that the active BIG-IP device failed over to the standby BIG-IP device. Which configuration settings should the BIG-IP Administrator verify to ensure proper behaviour when BIG-IP failover occurs?

1. A. cookie persistence and session timeout
2. B. Stateful failover and Network Failover detection
3. C. Persistence mirroring and Match Across Services
4. D. syn-cookie insertion threshold and connection low-water mark

Correct Answer: C

Which Virtual Server type prevents the use of a default pool?

1. A. Performance (Layer 4)
2. B. Forwarding (IP)
3. C. Performance HTTP
4. D. Standard

Correct Answer: B
Forwarding (IP) cannot be associated with the pool.

A BIG-IP has two load balancing virtual servers at 150.150.10.10:80 and 150.150.10.10:443. The port 80 virtual server has SNAT automap configured. There is also a SNAT configured at 150.150.10.11 set for a source address range of 200.200.1.0 / 255.255.255.0. All other settings are at their default states. If a client with the IP address 200.200.1.1 sends a request to https://150.150.10.10, what is the source IP address when the associated packet is sent to the pool member?

1. A. 200.200.1.1
2. B. 150.150.10.11
3. C. Floating self IP address on VLAN where the packet leaves the system
4. D. Floating self IP address on VLAN where the packet arrives on the system

Correct Answer: B